Back
Version 5.12 Build 16800 of 30th January 2020
New File Versions
- Library - DLL V5.12
- Control Center V2.16
Improvements
- [SPCMDRV-1562] Allow setting "M4i.22xx-ir40m" option (small input ranges) also for demo cards
- [SPCMDRV-2614] M2p.65xx-HV: Allow temperature reading from supervisor chip and print out health status to log file
- [SPCMDRV-2616] Remove XMODE features from X12 onwards if card is in a Netbox
- [SPCMDRV-2620] Control Center Monitor: print values smaller than 1.0 as milli [V|A|W]
- [SPCMDRV-2621] Show error messages in separate line
- [SPCMDRV-2630] Remove redundant "Version" from CC About tab
- [SPCMDRV-2635] Show features of all Multi-Purpose lines including the ones added by digital I/O option (-DigSMB or -DigFX2)
- [SPCMDRV-2639] Support for new firmware feature allowing conversion of RAW 8bit, 14bit and 16bit samples from default twos-complement to offset-binary
Fixed Bugs
- [SPCMDRV-314] Cannot open last demo card if real card in system has not been opened yet
- [SPCMDRV-2613] Python recording examples do not work correctly with 8bit cards
- [SPCMDRV-2615] Reported AVAILMODES for multi purpose lines >= X4 are zero on demo cards
- [SPCMDRV-2617] M4i.44xx: Default value for SPC_BOX_AVERAGES is wrong
- [SPCMDRV-2619] Monitoring of M2p.6546 crashes
- [SPCMDRV-2622] M2p-dig16: PCB and HW version are shown as 0.0 in Cntrol Center
- [SPCMDRV-2623] SPC_MODULEBPCBVERSION reads value of Module A
- [SPCMDRV-2629] Installation problems under CentOS
- [SPCMDRV-2634] Incorrect casting of module FW versions in EEProm
- [SPCMDRV-2638] Demodata generation not working correctly when having digital option digitalbits active
- [SPCMDRV-2642] Enabling digital outputs after having the card already started once creates incorrect outputs
- [SPCMDRV-2647] Model and SN displayed by LXI discovery tool are wrong