Suche

Sie sind hier

Digital I/O, Pattern Generators Basics | Spectrum

Digital I/O cards, pattern or pulse generators and digital data acquisition cards are all focused on digital signals. Input and output signals have two logic levels called low state (0) and high state (1). The electrical representation of these logical levels depends on the logic family and the supported I/O standard.

Devices by Function

  • Digital Data Acquisition or Logic Analyzers acquire digital data signals by sampling it with either an internal sampling clock or an external state clock. The acquired data is stored to the on-board memory or continuously transferred to host PC using the streaming (FIFO) mode. The acquisition can be triggered by external trigger signal or by complex pattern trigger just as known from logic analyzers.
  • Pattern Generators are used to generate digital electronics stimuli. The output levels can be either fixed and defined by the specification of the card or the levels can be individually programmed to a certain voltage level for low state and high state allowing to interfere with different external devices.
  • Digital I/O Cards combine the both functions of pattern generation and digital data acquisition in one device. At Spectrum the digital I/O cards are switched between the two functions by software and can either perform as a pattern generator or as a digital data acquisition card at the time.
  • Pulse Generators are used to generate some control pulses with defined width and distance on multiple lines. Using a standard pattern generator these pulse pattern can easily defined by the data. The time resolution of the pulse generator then equals to the programmed output rate of the pattern generator.

Interfacing

Different interface types are found for the digital devices as well as for the external devices to connect with. It is important for the correct function of both to check the specification details to see whether both devices fit together or not. All logic families have a defined voltage windows for low state and high state for output and for input where the output window is defined more narrow while the input window accept a wider variation. Showing the specification of the M2i.70xx digital I/O card series with TTL compatible inputs and outputs explains this:

  • Digital Output levels typical: low state 0.2 V, high state 2.8 V
  • Digital Output levels at max current load: low state 0.5 V, high state 2.0 V
  • Digital Input levels: low state -0.5 V to +0.8 V, high state +2.0 V to +7.0 V

Single-Ended versus Differential

Classic logic families like TTL or CMOS are all single-ended meaning that a single line is carrying the information in relation to a common Ground. Depending on the mechanical structure this ground may be a separate ground for each digital line or a shared ground for all digital lines.

Differential logic families like LVDS have a pair of cables for each digital lines carrying the logic information as differential signal. Using differential signaling allows to use far higher speed.